Leg injury cause?

[Ultum4Spiderz]

I’m wondering how this Ts leg got hurt took pictures of the cage . Found no proof of It getting hurt by the lid.

 

[Charliemum]

She could easily have slipped on the glass and landed funny on it. If where the web is is solid corkbark it gives a hard surface for her to land on . I have had a 5 inch blondi recently jump out of a catch cup while I was rehousing her , the cup was only 2 inches off her sub n she landed funny bent her bk foot bk. She seemed fine from it but dropped the leg on her recent moult so I assume it was worse then I thought but point being she managed it from a 2 inch drop onto fresh sub and moss n still hurt herself. It is easy for them to do this from much less of a height then you would think.
You may never know for sure but it would be my best guess. Hopefully she will be fine from it , I have everything crossed for yous .

 

[Smotzer]

I’m inclined to believe the same as @Charliemum pointed out above.

Also you said

Found no proof of It getting hurt by the lid.

This sounds like the lid is indeed woven wire mesh. Is that correct? You may have not personally seen it get stuck but it very likely could have.

 

[Brewser]

Hopeful for al full recovery in future.

Best wishes,

 

[jennywallace]

Agree sounds like a fall, even a short fall could do that damage, hope she is OK.

 

[viper69]

Prob fell

 

[TheraMygale]

The only thing i could see is falling.

you have the experience to see how this could happen. If you have more dirt add some.

i know you know this, but for others new to the board and tarantula husbandry, a big terrestrial tarantula like that, has less risk of injury if it is housed in an enclosure that: when tarantula stands on back legs, its front legs touch top of enclosure.

sure, i see tons of videos by great keepers, that keep their terrestrials in super low sub. its not because they don’t climb, that they might never.

 

[Mustafa67]

I’m wondering how this Ts leg got hurt took pictures of the cage . Found no proof of It getting hurt by the lid. View attachment 493956 View attachment 493957 View attachment 493958 View attachment 493959 View attachment 493960 View attachment 493961 View attachment 493962

Fell or slipped

 

[Ultum4Spiderz]

I’m inclined to believe the same as @Charliemum pointed out above.

Also you said

This sounds like the lid is indeed woven wire mesh. Is that correct? You may have not personally seen it get stuck but it very likely could have.

This type of lid I wanted to replace but ran out of money then it got too challenging to figure out how to replace it. Any tips ? Here’s the link https://arachnoboards.com/threads/how-to-replacing-zilla-screen-lid-or-modify-it.362739/post-3410035
Congrats on the promotion of moderator!!!

 

[jc1994]

looks like it got caught somewhere or slip or fall landing on that side and unfortunately bent it back, give it a couple of molts and it should be back to normal