HOITrance
Arachnosquire
- Joined
- May 10, 2022
- Messages
- 116
Looks good! The only thing I would caution on in the future is the gorilla glue. I don’t know what others use, but I use Aquarium silicone. I’m concerned the fumes from the glue could cause issues if your T respirates them.So I added a bunch more substrate, (lmk if it’s still lacking!) just couldn’t get enough into the right corner where my tarantula is hanging out right now.
Then I got 2 pieces of “double” ply plexiglass cut at my local Ace Hardware store. I measure the screen’s length & width only, then the whole lid’s dimensions. I did this so I’d have a “back up” lid while I glued the screen sized plexi to the underside of the original lid. I asked for help choosing the right drill bit for plastic, attached. It fit fine in my cheap hand drill I bought from Target. I read to tape the area before you drill, really helped keep the holes clean & made it easier. I practiced on the “back up” lid first. Go slow & gently-made some micro cracks bc I pushed too hard a couple times, & it slammed on the plexi.
Used gorilla glue to fix to underside of the lid, & held in place with gorilla tape for security.
May keep the extra lid I made taped to the top just in case, but only if it’s allowing enough air.
Thanks you all for the support- thankful I stumbled on this forum!