I couldn't find anyone to build a custom enclosure that i wanted, so i gave it a shot myself. THe reason behind building it the way i did, is that my Female P.Metallica is a huge (7.5"-8") angry, b!*t<h, and i don't like handling her. My male is housed in the center and the females on either side. All i have to do is slide the door up and the male can go into the female's enclosure for some humping, or run away scared back into his hide away from the angry female beast.
This is my first enclosure, i know it's not perfect, so don't flame me too bad.
It is made out of acrylic. I did my best to calculate all the measurements, and had it pre cut. I mis calculated 3 pieces and had to cut em down more, but the rest were ready for polishing the edges.
Instead of latches, i used magnets that are imbedded into acrylic.
I have a humidifier under the cabinet and plumbed it into all 3 enclosures. I also put a low amp heater (safe for plastic) taped across the back. Both are automatically controlled.
This is my first enclosure, i know it's not perfect, so don't flame me too bad.
It is made out of acrylic. I did my best to calculate all the measurements, and had it pre cut. I mis calculated 3 pieces and had to cut em down more, but the rest were ready for polishing the edges.
Instead of latches, i used magnets that are imbedded into acrylic.
I have a humidifier under the cabinet and plumbed it into all 3 enclosures. I also put a low amp heater (safe for plastic) taped across the back. Both are automatically controlled.